Switch Settings - Renesas Emulation Pod M306H7T3-RPD-E User Manual

M306H7T3-RPD-E User's Manual

2.9.4 Switch Settings

Here follows explanations of the switches of the emulation pod. Set the switches according to the user system.
Tables 2.3 and 2.4 list how to set toggle switches SW1 to SW5 of the M306H7T3-PRT board (MCU-dependent). Tables 2.5
and 2.6 list how to set jumper switches JP1 to JP7 on the M306H7T3-PRT (MCU-dependent board). For the positions of the
switches, see Figure 2.15.
(1) Toggle Switches SW1 to SW5 on the M306H7T3-PRT Board (MCU-dependent)
Table 2.3 Switch settings of the M306H7T3- PRT (1)
Signal
START
CNVSS
P87/Xcin
Xout
REJ10J0964-0100 Rev.1.00 August 01, 2005
Switch Setting
SW1
(Factory-setting)
SW2
SW3
SW4
L
Xin-Xout is selected as an operation clock after
releasing reset.
OPEN
H
H
Does not pull up/down pin START of the MCU.
OPEN
Be sure to use this setting when the user system
is connected.
L
H
Xcin-Xcout is selected as an operation clock after
OPEN
releasing reset.
L
Pulls down pin CNVSS of the MCU with a
L
resistance of 1 kΩ. Be sure to use this setting
OPEN
when the user system is not connected.
H
L
Does not pull up/down pin CNVSS of the MCU.
OPEN
Be sure to use this setting when the user system
is connected.
H
L
Do not use this setting.
OPEN
H
P87
When using the P87/Xcin of the MCU as a port
P87 function
Xcin
P87
When using the P87/Xcin of the MCU as a port
Xcin function
Xcin
OPEN
Does not connect pin Xout of the MCU to the user
system.
Xout
OPEN
Connects pin Xout of the MCU to the user system.
Xout
Description
(Factory-setting)
(Factory-setting)
(Factory-setting)
(Factory-setting)
2. Setup
Page 42 of 88