Table of Contents
Advertisement
M306H7T3-RPD-E User's Manual
3.6 Hardware Break
Hardware break is set by event condition such as FETCH or DATA ACCESS, etc. The program stops after executing the
instruction at the set breakpoint (after several cycles).
(1) Break event setup dialog box
1) Opening the hardware break point setup dialog box
2) Hardware Break Point Setting Window in initial state
3) Break event setting dialog box
REJ10J0964-0100 Rev.1.00 August 01, 2005
3. Usage (How to Use the Emulator Debugger)
Hardware Break Point
Clicking this button opens the hardware break point setup dialog box.
Hardware break point Setting Window in initial state
Select the "Enable H/W Break" check box, and this break function will be
enabled, allowing you to set hardware break points.
Setting Break Event
Click the event line at which you want set a break event.
Specifying the event type
Click to select the event type you want to set.
- FETCH
Detects an instruction prefetch.
- DATA ACCESS
Detects a memory access.
- BIT ACCESS
Detects a bit access.
- INTERRUPT
Detects an occurrence of interruption or interrupt completion.
- TRIGGER
Detects a signal from the external trace signal input cable.
Page 60 of 88
Advertisement
Table of Contents
