Renesas Emulation Pod M306H7T3-RPD-E User Manual page 19

M306H7T3-RPD-E User's Manual
(2) Target Status LEDs
The target status LEDs indicate the target MCU's operating status and target board's power supply. Table 1.4 lists the definition
of each target status LED.
Table 1.4 Definitions of the target status LEDs
Name Status
ON
POWER
OFF
ON
CLOCK
OFF
ON
RESET
OFF
ON
RUN
OFF
ON
HALT
OFF
Note on the Target Status POWER LED:
If your MCU has two or more power supply terminals (Vcc), you need to supply power to all the
terminals.
Note on the Target Status CLOCK LED:
If the LED is not turned on, check the following.
(1) After powering on the PC4701 (before starting up the emulator debugger):
Make sure that the oscillator circuit board in the emulation pod is properly installed and it is
oscillating normally.
(2) After the emulator debugger is started up (after the Init dialog box settings are completed):
Make sure that the oscillator selected in the Init dialog box is oscillating normally.
REJ10J0964-0100 Rev.1.00 August 01, 2005
Power is supplied to the user system.
Power is not supplied to the user system.
Target MCU clock is oscillating.
Target MCU clock is not oscillating.
Target MCU is being reset, or reset signal of the user system is held low.
Target MCU is not being reset.
User program is being executed.
User program has been halted.
CPU clock of target MCU is not oscillating.
CPU clock of target MCU is oscillating.
IMPORTANT
Meaning
1. Outline
Page 17 of 88