Installing And Removing Network Resistors For Pullup - Renesas Emulation Pod M306H7T3-RPD-E User Manual

M306H7T3-RPD-E User's Manual

2.9.5 Installing and Removing Network Resistors for Pullup

In this product, you cannot control pullup for ports P0 to P5 by pullup control registers (pullup control register read/write are
possible).
A socket for installing the network resistor for pullup is mounted in this product. Mount the 51 kΩ network resistor supplied
with this product to the port for which pullup control is required. For the mounting location, refer to Figure 2.21 below. And
for the positions of each part, refer to Figure 2.15.
RM1
RM6
VCC
VCC
VCC
VCC
VCC
VCC
VCC
Figure 2.21 Position for mounting network resistors for pullup
Note on Installing and Removing Network Resistors for Pullup:
Always shut OFF power before installing or removing network resistors for pullup. Also install
network resistors for pullup properly. Otherwise, internal circuit board may be damaged.
REJ10J0964-0100 Rev.1.00 August 01, 2005
P07 P06 P05
P17 P16 P15
P27 P26 P25
P37 P36 P35
P47 P46 P45
P57 P56 P55
CAUTION
P04 P03 P02
P14 P13 P12
P24 P23 P22
P34 P33 P32
P44 P43 P42
P54 P53 P52
P01 P00
P11 P10
P21 P20
P31 P30
P41 P40
P51 P50
2. Setup
Page 45 of 88