Selecting Clock Supply - Renesas Emulation Pod M306H7T3-RPD-E User Manual

M306H7T3-RPD-E User's Manual

2.9.3 Selecting Clock Supply

(1) Clock Supply to the MCU
You can choose a clock supplied to the evaluation MCU by the Emulator tab in the Init dialog box of the emulator debugger.
Table 2.2 lists the factory-settings of each clock supply when you install the emulator debugger.
Table 2.2 Clock Supply to the MCU
Clock Display of emulator debugger
Main (X -X
IN OUT)
Sub (X -X
CIN COUT)
Note on Changing the Clock Supply:
The clock supply can be set in the Init dialog box when starting up the emulator debugger or inputting
CLK command on the script window.
For pins X
Switch Settings" (page 42)
(2) Using the Internal Oscillator Circuit Board
An oscillator circuit board for 16.0 MHz (OSC-3) is mounted on this product. Also the oscillator circuit board (OSC-2) is
attached to change the oscillation frequency. When you use an internal oscillator circuit as a main clock, "Internal" can be set
by the emulator debugger.
REJ10J0964-0100 Rev.1.00 August 01, 2005
Internal
External
Internal
External
IMPORTANT
-X , it is necessary to set the switches in the emulation pod. For details, refer to "2.9.4
CIN COUT
Description
Internal oscillator circuit of emulation pod
(OSC-3: 16.0 MHz or OSC-2)
User system
Internal oscillator circuit of emulation pod
(32.768 kHz)
User system
2. Setup
Default setting
Yes
-
-
Yes
Page 38 of 88