Starting Up The Emulator Debugger; Init Dialog Box - Renesas Emulation Pod M306H7T3-RPD-E User Manual

M306H7T3-RPD-E User's Manual

3.3 Starting Up the Emulator Debugger

When debugging the completed programs, switch the session. The session can be changed by the drop down list of the tool bar
shown below.
You will have as many sessions created as the number of targets you selected when creating a project, so select the session that
corresponds to the target to be connected from the drop-down list. Select "SessionM16C_PC4701_Emulator"

3.3.1 Init Dialog Box

After specifying the session, an Init dialog box to connect the target is displayed.
The Init dialog box is used to set the items that need to be set when the emulator debugger starts up. The contents set in this
dialog box remain effective the next time you start the debugger.
(1) MCU tab
1) Specifying the MCU file
Cancel
Look in:
File name:
File of type:
Cancel
REJ10J0964-0100 Rev.1.00 August 01, 2005
Help
Open
Cancel
Help
3. Usage (How to Use the Emulator Debugger)
Specifying the MCU file
Specify the MCU file for the target MCU.
(1) Click the "Refer..." Button".
(2) "Select MCU File" dialog box will be displayed. Specify the MCU file
for the target MCU.
- The MCU file contains the information specific to the target MCU.
- The specified MCU file is displayed at the MCU area field of MCU tab.
Page 49 of 88