Table of Contents
Advertisement
M306H7T3-RPD-E User's Manual
4) Specifying the clock frequency
Cancel
(2) Debugging Information tab
Cancel
REJ10J0964-0100 Rev.1.00 August 01, 2005
Help
Help
3. Usage (How to Use the Emulator Debugger)
Specifying the clock frequency
Specify the target MCU operation clock and clock dividing ratio.
- Specify the operation clock and clock dividing ratio.
- In case where no value was set up in the area in which the operation clock
is Specified, the unit operates with the reference clock (16 MHz) inside
the emulator (PC4701) as time measurement resource.
- In case where no value was set up in the area in which the dividing ratio is
Specified, the unit operates as "No dividing". (Same as when "1" was
Specified.)
Referencing the compiler used and the object format
Reference the compiler you are using and the format of the object file output
by the compiler.
To make this setting, use the dialog box that is brought up by selecting
[Debug] and then [Debug Settings...] from the menu.
Specifying the method for storing debug information
There are two methods for storing debug information: on memory method
and an on demand method.
Select the compiler you are using.
(By default, the on memory is selected)
When selecting the on demand method, check the [On Demand] check box.
On Memory
The debug information is stored in the memory of your computer. This
method is suitable when the size of the load module (user program) is
small.
On Demand
The debug information is saved to a reusable temporary file. When you
download the same load module for a second time on, the saved debug
information will be reused and the load module can therefore be
downloaded fast. This method is suitable when the size of the load module
(user program) is large.
Page 52 of 88
Advertisement
Table of Contents
