Renesas Emulation Pod M306H7T3-RPD-E User Manual page 45

M306H7T3-RPD-E User's Manual
Table 2.4 Switch settings of the M306H7T3- PRT (2)
Signal
P86/Xcout
Note on Switch Settings:
Always shut OFF power before changing switch setting. Otherwise, internal circuit board may be
damaged.
Note on START and CNVSS Switch Settings:
Switch settings of the START and CNVSS are for debugging without the user system connected.
(2) Jumper Switches JP1 to JP7 on the M306H7T3-PRT Board (MCU-dependent)
Table 2.5 Switch settings of the M306H7T3- PRT (3)
Signal Switch
SYNCIN
CVIN
VCCOFF
REJ10J0964-0100 Rev.1.00 August 01, 2005
Switch Setting
SW5
IMPORTANT
JP1
Connects pin SYNCIN to internal
circuit of the M306H7T3-PRT.
JP2
Connects pin CVIN to the user system
via the M3T-FLX160C.
JP3
Pin VCCOFF is to fixed to high..
P87
Connects pin P86/Xcout of the MCU to the user
Xcout
system.
Xcin
P87
Does not connect pin P86/Xcout of the MCU to
the user system.
Xcin
CAUTION
Setting of jumper switches
FLX
INT
Connects pin SYNCIN to the user
system via the M3T-FLX160C.
FLX
INT
Connects pin CVIN to the user system
via the M3T-FLX160C.
FLX
INT
Connects pin VCCOFF to the user
system via the M3T-FLX160C.
Description
(Factory-setting)
FLX
INT
(Factory-setting)
FLX
INT
(Factory-setting)
FLX
INT
(Factory-setting)
Page 43 of 88
2. Setup