Renesas Emulation Pod M306H7T3-RPD-E User Manual page 46

M306H7T3-RPD-E User's Manual
Table 2.6 Switch settings of the M306H7T3- PRT (4)
Signal Switch
VCC1
VDDA
na
JC1_R
TVDD
Note on Switch Settings:
Always shut OFF power before changing switch setting. Otherwise, internal circuit board may be
damaged.
REJ10J0964-0100 Rev.1.00 August 01, 2005
JP4
Connects pin VCC1 of the MCU to
the internal power supply of pod
(equipotential of VCC2).
VDD2
JP5
Do not use this setting.
JP6
Does not pull down video input signal
(RCA connector).
V50
JP7
Do not use this setting.
Setting of jumper switches
FLX
INT
V50/TVDD
JC1_R
TVDD
CAUTION
FLX
INT
Connects pin VCC1 of the MCU to
the user system. Be sure to use this
setting when the potentials of VCC1
and VCC2 are different.
(Factory-setting)
VDD2 V50/TVDD
Be sure to use this setting.
(Factory-setting)
JC1_R
Pulls down video input signal (RCA
connector) with a resistance of 75 Ω
(Factory-setting)
V50 TVDD
Be sure to use this setting.
(Factory-setting)
2. Setup
Page 44 of 88