Table of Contents
Advertisement
M306H7T3-RPD-E User's Manual
(2) Software break
1) Setting the software break point
2) Execution completed with software break
REJ10J0964-0100 Rev.1.00 August 01, 2005
3. Usage (How to Use the Emulator Debugger)
Execution setup procedure with software break:
By double-clicking the break point setting line on the software
(1)
break point setting column in the editor (source) window, the
break point can be set up and released. (In this case, the red circle
is displayed on the setting line as shown in the window on the
left.)
(2)
Click the execution button.
The cursor stops in the position where the software break was set up.
The statement in which the software break was set up is not executed.
Page 58 of 88
Advertisement
Table of Contents
