If An Error Is Detected In The Self-Check - Renesas Emulation Pod M306H7T3-RPD-E User Manual

M306H7T3-RPD-E User's Manual
SW1
SW3
SW5
Figure 2.8 Switch settings for the self-check (factory-settings)

2.7.2 If an Error is Detected in the Self-check

If the self-check does not result normally (system status error or target status error in Figure 2.7), check the following.
Whether the emulation pod and PC4701 are connected properly
Whether the proper firmware has been downloaded
Whether the switch settings of this product are the factory-settings
Notes on Self-check:
Perform the self-check while not connecting the user system.
If the self-check does not result normally (excluding user system error), the emulation pod may be
damaged. Then contact your local distributor.
REJ10J0964-0100 Rev.1.00 August 01, 2005
L L
OPEN OPEN
H H
SW2
P87
OPEN
Xcin Xout
SW4
P86/
Xcout
OPEN
IMPORTANT
FLX FLX
JP1 JP2
INT INT
FLX
JP4
INT
VDD2 V50/TVDD JC1_R
JP5 JP6
FLX
JP3
INT
V50 TVDD
JP7
Page 30 of 88
2. Setup