Setup; Flowchart Of Starting Up The Emulator - Renesas Emulation Pod M306H7T3-RPD-E User Manual

M306H7T3-RPD-E User's Manual

2. Setup

This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.

2.1 Flowchart of Starting Up the Emulator

The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when the
emulator does not start up normally, refer to "5. Troubleshooting" (page 80).
Check the package components.
User registration
Install the M16C PC4701 Emulator
Debugger.
Connect the host machine.
Connect the emulation pod to the emulator.
Connect the power supply for the emulator.
Connect the user system.
Turning on the power supply.
Check the LED display of the emulator.
Start up the emulator debugger from the
High-performance Embedded Workshop.
Set the operating environment
of the emulator debugger.
Debug a program with various functions of
the emulator debugger
Figure 2.1 Flowchart of starting up the emulator
REJ10J0964-0100 Rev.1.00 August 01, 2005
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
Refer to "1.1 Package Components" (page 13).
Refer to "User Registration" (page 11).
Install the M16C PC4701 Emulator Debugger.
Connect the PC4701 to the host machine with each interface
connector.
Set the interface selection switch on the rear panel of the PC4701 to
the using interface.
Connect the emulation pod M306H7T3-RPD-E using the
FLX120-RPD to the PC4701 (Be sure to see "2.4.3 PC4701 and
Emulation Pod Arrangement" on page 25).
Connect a power supply for the emulator.
Connect the user system as occasion demands.
Turn ON the power to the emulator and the user system as
simultaneously as possible.
Check that system status LED, and POWER, CLOCK, RESET and
WARNING of target status LED are lighting. When the user system
is not connected, the POWER LED does not light up.
Start up the High-performance Embedded Workshop, and the
emulator debugger.
Set the INIT dialog box of the emulator debugger.
For how to use the High-performance Embedded Workshop and the
emulator debugger, refer to each online manual.
2. Setup
Page 20 of 88