Table of Contents
Advertisement
Chapter 3. Setting Up
With this product, it is necessary to set the following according to your target system.
3.1 Switch Settings
It is necessary to set the switches of the FLX64-PRB for debugging according to the target system.
Figure 3.1 shows the positions of the switches of the FLX64-PRB, and Table 3.1 shows the switch
settings.
Figure 3.1 Positions of the switches and their factory-settings
Table 3.1 Switch settings of the FLX64-PRB
Switch No.
Note on Settings of JP1 and JP2:
• Switching ports (P70 and P71) and sub-clock
• Mounting the A-D conversion bypass capacitor
Function
Switches
JP1
P71/X
CIN
Switches
JP2
P70/NC
• Change the switch setting of JP1 and JP2 at the same time as shown in Table 3.1.
PORT
XCIN
When using the port function (P71)
(Factory-setting)
PORT
NC
When using the port function (P70)
(Factory-setting)
IMPORTANT
( 18 / 38 )
Switch setting
When using the sub-clock
When using the sub-clock
PORT
XCIN
PORT
NC
Advertisement
Table of Contents
