Table of Contents
Advertisement
M306H7T3-RPD-E User's Manual
Cancel
Cancel
3) Executing the self-check
Cancel
REJ10J0964-0100 Rev.1.00 August 01, 2005
Help
Help
Help
3. Usage (How to Use the Emulator Debugger)
Specifying
the
communication
communication)
- For selecting the LPT communication, click the radio button "LPT" of the
MCU tab.
- For the Type area, specify the LPT interface communication mode to be
used.
- Specify the I/O address of the parallel port at the I/O address area.
- For BIOS setup, the following addresses are available.
- 378h
- 278h
Specifying
the
communication
communication)
- For selecting the USB communication, click the radio button "USB" of
the MCU tab
- The emulators connected by USB cable are shown at Serial No. area.
Select the serial No. of the emulator you are going to connect.
- Select the serial No. of the emulator you are going to connect.
Executing the self-check
Enable this function when you want the emulator to be self-checked at
startup. Be sure to select the check box only when you want the emulator to
be self-checked at startup.
Note:
In case where self-checking was normally completed, terminate the
emulator debugger once, then start operation with no self-checking
carried out again (with leaving the check box unchecked).
This function may be enabled in the following cases:
- When you are using the emulator you have just purchased, and fail to
download the firmware.
- When you successfully download the firmware, but fail to start up the
emulator
- When you want to confirm whether the emulator is operating normally
because, for example, the MCU runs out of control or something is wrong
with the trace results
This function can be enabled only when you are starting up the emulator
debugger.
interface
(LPT
interface
(USB
Page 51 of 88
Advertisement
Table of Contents
