Installation Tools; Option Components; Option Pcb Components; Communication Connector - YASKAWA PROFINET JOHB-SMP3 Technical Manual

4 Option Components

*4 The LED label has transparent background and white letters. Please make sure that you use the correct label for Z1000, HV600, or
FP605.
◆

Installation Tools

You can use these tools to install the option to the drive:
• A Phillips screwdriver or slotted screwdriver
• Non-conductive tweezers or a tool with a tip width of approximately 0.5 mm (0.02 in) to set DIP switch S1.
• A pair of diagonal cutting pliers.
• A small file or medium-grit sandpaper.
*1 Phillips screw sizes are different for different drive capacities. Prepare different screwdrivers for different
screw sizes.
4 Option Components
◆

Option PCB Components

A - Connector (CN5)
B - Installation hole
C - LED (NS)
*1
D - LED (MS)
*1
E - Ground terminal (FE) and installation hole
F - Port 2 LED (10/100)
*1 Refer to Option LED States on page 11
*2 Connect the included ground wire during installation. The ground wire is not necessary for installation on GA700, GA800, and
CR700 drives. For GA500 drives, connect the included ground wire to the separately-sold communication option case (model:
JOHB-GA50).
◆

Communication Connector

Option connections CN1A (Port 1) and CN1B (Port 2) are connection points for customer-supplied PROFINET
network communication cables. These ports accept customer-supplied male 8-way ethernet modular RJ45
connectors.
Table 4.1 Male 8-way Ethernet Modular Connector (Customer-Supplied)
Male 8-way Ethernet Modular Connector
10
.
*1
*2
*1
Figure 4.1 Option PCB Components
for more information about the LEDs.
G - Option modular connector CN1B (Port 2) (RJ45)
H - DIP switch S1
I - Port 2 LED (LINK/ACT)
J - Port 1 LED (10/100)
*1
K - Option modular connector CN1A (Port 1) (RJ45)
L - Port 1 LED (LINK/ACT)
Pin
1 (Pair 2)
2 (Pair 2)
3 (Pair 3)
4 (Pair 1)
5 (Pair 1)
6 (Pair 3)
7 (Pair 4)
8 (Pair 4)
YASKAWA SIEP C730600 0KA PROFINET Technical Manual
*1
*1
Description
Transmit data (TXD) +
Transmit data (TXD) -
Receive data (RXD) +
Not used
Not used
Receive data (RXD) -
Not used
Not used