Table of Contents
Advertisement
Nesis III User's Manual
N/D calibration sets antenna calibration value. A higher value makes non-
directional targets appear closer — it compensates for low antenna gain
and/or a long cable.
N/D target beep enables/disables beep sound on the device for non-directio-
nal targets. Note: not all Flarm devices have such beeper available
and/or activated. This does not affect Nesis.
5.4.4
Range Settings
The range related settings define range filters of the device. According to our
experiences, only Power Flarm accepts these settings properly.
Please note that actual detection capabilities of the device may be significantly
lower then specified by these values. Especially, all metal and carbon aircraft
are affected.
Flarm horizontal range (m) defines the horizontal distance cut-off limit
for targets detected by Flarm to Flarm radio signal. Targets beyond
this limit will not be shown.
Flarm vertical range (m) defines the vertical distance cuf-off limits for
targets detected by Flarm to Flarm radio signal.
ADS-B horizontal range (m) defines the horizontal distance cut-off limit
for targets detected by ADS-B squitter response.
ADS-B vertical range (m) defines the vertical distance cut-off limit for tar-
gets detected by ADS-B squitter response.
N/D horizontal range (m) defines the horizontal distance cut-off limit for
non-directional targets. Please note, that distance is estimated on the
signal strength.
N/D vertical range (m) defines the vertical distance cut-off limit for non-
directional targets.
5.5
Errors
Flarm device may send error and warning messages, which indicate device's
internal problems. When Nesis intercepts them, a red Flarm symbol is flashing
in the status bar. In addition a Flarm status rectangle appears on the right
side of the main map screen indicating number of errors. See Figure 46 left.
73
5.5 Errors
© Kanardia 2018-2022
Advertisement
Table of Contents
