Table of Contents
Advertisement
Nesis III User's Manual
When a connection was not established, no sysmbol will apear. This means
that either device is not present or it is not working or Nesis does not commu-
nicate properly with the device (wrong baud rate, parity, wrong connection,
etc.)
3.4.1
GDL90 Devices
When an ADS-B device is connected with Nesis either over WiFi or directly
with a cable and GDL90 communication protocol is used, the the following
symbols appear.
A gray symbol indicates that communication with device was
established, but the device is still not ready.
A cyan symbol indicates that communication with device was
established and the device is ready to be used – it is working
properly.
A red symbol indicates that device is in errorneous state and it
should not be trusted.
When a connection was not established, no sysmbol will apear. This means
that either device is not present or it is not working or Nesis does not commu-
nicate properly with the device (wrong baud rate, parity, wrong connection,
etc.)
Radio and WiFi Symbols
A communication with COM radio device was established.
A WiFi module was detected and communication was estab-
lished. Note that this does not automatically mean that Nesis is
also connected to the Internet.
3.5
Screens
Nesis can show different screens. Typically four screens are shown, but this
number is not fixed. We work closely together with a customer and we prepare
special screen layout for each customer/aircraft. Figure 4 shows examples of
these four screens.
24
3.5 Screens
© Kanardia 2018-2022
Advertisement
Table of Contents
