Reassembly And Remounting - Suzuki GSX1200 1999 Service Manual

PIVOT SHAFT
Measure the pivot shaft runout using the dial gauge. If the pivot
shaft exceeds the service limit, replace it with a new one.
! ! ! ! ! 09900-20606: Dial gauge (1/100 mm, 10 mm)
09900-20701: Magnetic stand
09900-21304: V-block (100 mm)
# # # # # Swingarm pivot shaft runout
Service Limit: 0.3 mm
REAR SHOCK ABSORBERS
Inspect the rear shock absorbers for damage and oil leakage. If
any defects are found, replace the rear shock absorber(-s) with a
new one.
"
Do not attempt to disassemble the rear shock absorber.
It is unserviceable.

REASSEMBLY AND REMOUNTING

Reassemble and remount the swingarm and rear shock absorb-
ers in the reverse order of removal and disassembly. Pay attention
to the following points:
SWINGARM NEEDLE BEARINGS
• Before installing the needle bearings, install the center spacer.
• Press the needle bearing into the swingarm pivot using the spe-
cial tool.
! !
! ! ! 09941-34513: Steering race installer
NOTE:
Install the needle bearings with the stamped mark facing out.
• Apply grease to the spacers, dust seals and needle bearings.
$ $ 99000-25010: SUZUKI SUPER GREASE "A" $
$ $
• Tighten the pivot shaft nut to the specified torque.
% % % Pivot shaft nut: 100 N . m (10.0 kgf-m) % %
CHASSIS 5-35