Suzuki GSX1200 1999 Service Manual page 100

• Install the generator with three bolts.
# # # # Generator mounting bolt: 25 N . m (2.5 kgf-m) #
NOTE:
Apply SUZUKI SUPER GREASE "A" to the generator O-ring.
* * * 99000-25010: SUZUKI SUPER GREASE ''A''
* *
• Install the starter motor with two bolts.
# #
# # Starter motor mounting bolt: 6 N . m (0.6 kgf-m) #
NOTE:
* Apply SUZUKI SUPER GREASE "A" to the starter motor O-
ring.
* Apply a small quantity of THREAD LOCK "1342" to the two bolts.
* * * 99000-25010: SUZUKI SUPER GREASE ''A''
* *
" " 99000-32050: THREAD LOCK ''1342'' "
" "
• Install the piston rings in the order of oil ring, 2nd ring and top
ring.
• Top ring and 2nd (middle) ring differ in the shape of ring face,
and the face of top ring is chrome-plated where as that of ring is
not.
• Top and 2nd (middle) rings have letter "N" marked on the upper
side.
NOTE:
Be sure to bring the marked side to top when fitting them to the
piston.
• The first member to go into the oil ring groove is a spacer 1.
After placing spacer, fit the two side rails 2.
Side designations, top and bottom, are not applied to the spacer
and side rails: you can position each either way.
!
When installing the spacer, be careful not to allow its two
ends to overlap in the groove.
• Position the gaps of the three rings as shown. Before inserting
each piston into the cylinder, check that the gaps are so lo-
cated.
Top ring
2nd ring
EX
• 2nd ring
• Lower side rail
120°
120°
120°
• Top ring
• Spacer
IN
ENGINE 3-65
INCORRECT
CORRECT
• Upper side rail