Suzuki GSX1200 1999 Service Manual page 95

3-60 ENGINE
• Install the clutch sleeve hub onto the countershaft.
• Insert the clutch drive plates and driven plates one by one into the clutch sleeve hub in the prescribed
order, No.2 drive plate first.
DRIVE PLATE:
Two kinds of the drive plate, No.1 and No.2, are equipped in the clutch system, they can be distin-
guished by the inside diameter.
A No.1 Drive Plate (Inside Diameter): 101 mm ..... 9 pcs
B No.2 Drive Plate (Inside Diameter): 108 mm .....1 pc
DRIVEN PLATE:
Two kinds of the driven plate, No.1 and No.2, are equipped in the clutch system, they can be distin-
guished by the thickness.
a No.1 Driven Plate (Thickness): 1.6 mm .....7 pcs
b No.2 Driven Plate (Thickness): 2.0 mm ..... 2 pcs
• Put the clutch pressure plate onto the clutch sleeve hub se-
curely.
• Put the clutch diaphragm spring seat 1 and clutch diaphragm
springs 2 onto the clutch pressure plate properly.
NOTE:
Pay attention to the direction of the clutch diaphragm springs.
( $ 3-62)
Direction
of inside