Suzuki GSX1200 1999 Service Manual page 78

• Remove the lower crankcase, and measure the width of com-
pressed plastigauge in the usual manner.
! ! Crank journal bearing oil clearance !
! !
Standard: 0.020 – 0.044 mm
Service Limit: 0.08 mm
• If the width at the widest part exceeds the limit, replace the set
of bearings with new ones by referring to the selection table.
• Check the corresponding crankcase journal I.D. code number
1, "A" or "B" which are stamped on the rear of upper crankcase.
• Check the corresponding crankshaft journal O.D. code number
2, "A", "B" or "C" which are stamped on the crankshaft.
Bearing selection table
Code
A
Conrod
I.D. 1
B
Crankcase I.D. specification
Code
A
B
Crankshaft journal O.D. specification
Code
A
B
C
" " " " " 09900-20202: Micrometer (25 – 50 mm)
Crank pin O.D. 2
A B
Green Black
Black Brown
I.D. specification
39.000 – 39.008 mm
39.008 – 39.016 mm
O.D. specification
35.992 – 36.000 mm
35.984 – 35.992 mm
35.976 – 35.984 mm
C
Brown
Yellow
ENGINE 3-43