Suzuki GSX1200 1999 Service Manual page 89

3-54 ENGINE
• Fit the O-rings, 1 and 2, and dowel pins 3 to the correct posi-
tions, as shown in the illustrations.
!
Replace the O-rings with new ones to prevent oil leak-
age.
• Install the oil pump to the lower crankcase with three bolts and
tighten them to the specified torque.
NOTE:
Apply a small quantity of THREAD LOCK "1342" to the bolts.
" 99000-32050: THREAD LOCK ''1342'' " "
" "
# Oil pump mounting bolt: 14 N . m (1.4 kgf-m) # # # #
NOTE:
Check the oil jets 4 fitted on the lower crankcase for clogging.
• Fit the bearing pins 5 and C-rings 6 on the upper crankcase.
• Install the countershaft assembly and driveshaft assembly on
the upper crankcase.
NOTE:
* Be sure to install the bearing dowel pins 7 in their respective
positions.
* Install the countershaft end cap to the position 8 .
* Make sure that the countershaft turns freely while holding the
driveshaft. If not, shift the gear to the neutral position.
NOTE:
Before fitting the crankshaft journal bearings, check the piston oil
jets 9 fitted on the upper crankcase for clogging.
9 Piston oil jet (4 pcs) ............For upper case