Side-Stand/Ignition Interlock System Part Inspection - Suzuki GSX1200 1999 Service Manual

Apply 12 volts to terminals A and B, and check the continuity
between the positive and negative terminals.
If the starter relay clicks and continuity is found, the relay is OK.
! 09900-25008: Multi circuit tester set ! !
! !
" " " " Tester knob indication: Continuity test (# "
&
Do not apply battery voltage to the starter relay for more
than five seconds.
This may overheat and damage the relay coil.
Check the relay coil for opens, grounds and the specified resis-
tance.
$ $ $ $ $ Starter relay resistance
Standard: 3 – 5 Ω Ω Ω Ω Ω
SIDE-STAND/IGNITION INTERLOCK SYSTEM
PART INSPECTION
If the interlock system does not operate properly, check each
component. If any abnormality is found, replace the component
with a new one.
NEUTRAL SWITCH
The neutral position indicator switch coupler is located under the
fuel tank.
• Remove the seat. (% 5-2)
• Remove the fuel tank. (% 4-3)
• Disconnect the neutral position indicator switch coupler and
measure the continuity between Blue and Ground with the trans-
mission in neutral.
ON (in neutral)
OFF (not in neutral)
# # # ) #
Blue Ground
ELECTRICAL SYSTEM 6-23
To starter motor - + To battery