Suzuki GSX1200 1999 Service Manual page 103

3-68 ENGINE
• Tighten the twelve 10-mm nuts to the specified torque with a
torque wrench sequentially in the ascending order of numbers.
# Cylinder head nut: 38 N . m (3.8 kgf-m) # #
# #
• After firmly tightening the twelve 10-mm nuts, install one 6-mm
bolt A and tighten it to the specified torque.
# #
# # Cylinder head bolt: 10 N · m (1.0 kgf-m) #
• Place the cam chain guide 1 properly.
• While holding down the cam chain, rotate the crankshaft in
normal direction to bring the "T" mark on the rotor to the center
of pick-up coil.
!
To turn over crankshaft, torque nut with a 19 mm wrench.
Never try to rotate crankshaft by putting a 6 mm T-type
wrench over the bolt.
NOTE:
Just before placing the camshaft on the cylinder head, apply mixed
engine oil/moly paste to its journals fully, taking care not to leave
any dry spot. Apply engine oil to the camshaft journal holders.
% % % 99000-25140: SUZUKI MOLY PASTE
% %