Disassembly/Reassembly Process; Access Panel Replacement - Inspur NF5180M6 User Manual

4.4

Disassembly/Reassembly Process

1. Before installation or removal of any hardware, always ensure all data is
backed up properly.
2. Disconnect the server and all attached devices from their electrical outlets.
3. There is no need to remove power from the server when replacing hot-swap
components.
4. If more than one option is to be installed, read the installation instructions
for all the hardware options and identify similar steps to streamline the
installation process.
Item appearance may be different on actual models.

4.4.1 Access Panel Replacement

To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching.
For proper cooling, do not operate the server without the access panel, air duct,
or fans installed. If the server supports hot-swap components, minimize the
amount of time the access panel is open.
To remove the access panel:
1. Loosen the screw on the hood latch anticlockwise to the unlocked position with a
Phillips screwdriver.
2. Lift up the hood latch handle to the unlocked position until the access panel slides
back and the tabs on the access panel disengage from the guide slots on the
chassis.
3. Hold the access panel on both sides and remove it.
26