Raid Controller Card Replacement - Inspur NF5180M6 User Manual

Figure 4-53 Removing the PCIe Card
To install the PCIe card:
1. Take the new PCIe card from the antistatic bag.
2. Align and insert the PCIe card to the Riser card slot.
3. Align and insert the PCIe Riser-Card assembly to the slot on the motherboard.
4. Press and rotate the latch 180° clockwise to secure the PCIe Riser cage in place.
5. Connect the cables of the PCIe card.
6. Install the access panel.

4.4.14 RAID Controller Card Replacement

The illustrations below are for demonstration only. The location and direction of
the RAID controller card may vary depending on the purchased machine
configuration.
To remove the RAID controller card:
1. Remove the access panel (Refer to Access Panel Replacement).
2. Remove the crossbar (Refer to Crossbar Replacement).
3. Disconnect the SAS cables of the RAID controller card. Take a picture of the cables
to avoid wrong cabling when installing.
4. Loosen the two screws securing the RAID controller card to the motherboard
anticlockwise with a Phillips screwdriver.
5. Remove the RAID controller card, and put it into an antistatic bag.
57