Ocp 3.0 Nic Replacement - Inspur NF5180M6 User Manual

Verify that the fan status LED is off after powering on the server.

4.4.6 OCP 3.0 NIC Replacement

The illustrations below are for demonstration only. The location and direction of
the OCP 3.0 NIC may vary depending on the machine configuration you
purchased.
To remove the OCP 3.0 NIC:
1. Loosen the thumbscrew securing the OCP NIC to the server anticlockwise.
2. Pull out the OCP 3.0 NIC from the server, and put it into an antistatic bag.
Figure 4-12 Removing the OCP 3.0 NIC
To install the OCP 3.0 NIC:
1. Take the new OCP 3.0 NIC out from the antistatic bag.
2. Insert the OCP 3.0 NIC into the card slot until it snaps into place.
3. Tighten the thumbscrew securing the OCP 3.0 NIC to the server clockwise.
33