Agilent Technologies 5975T LTM GC Operation Manual page 53

3 Using two wrenches against each other, tighten the two nuts together a little
4 Remove the swaging nut or swaging tool.
5975T LTM GC/MSD Operation Manual
Thread the swaging nut or swaging tool onto the internal nut with the
column protruding.
at a time, occasionally checking to see if the ferrule is gripping the column.
When the ferrule starts to grip, tighten one of the nuts an additional 45 to
60 degrees (one flat).
Installing LTM Columns
2
53