Agilent Technologies 5975T LTM GC Operation Manual page 51

10 Remove the green column cable connector from the small circuit board
Figure 14
11 Remove the two blue transfer line cable connectors from the connectors, J2
12 Remove the fan cable from the bottom connector.
13 Slide the bushing securing the cable bundle out of the attachment point on
14 Cap the column ends and place the column module assembly in its storage
5975T LTM GC/MSD Operation Manual
connector, J1.
J2 and J3 cable
connectors
J1 cable
connectors
LTM cable connections
and J3 them by gripping the connector. Do not pull on the cable because
there are several fine wires in the connector that can be broken. See
Figure 14.
the frame to finish removing the column module assembly. See
container.
Installing LTM Columns
Figure
2
13.
51