Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual page 158

Symbol Name
A All online
B Connection check LED all-OFF
C St. No.
D Connection status
E Switch online/offline
F Operating status
G Operation command
H Operation mode
I Current warning
J Error code
K Connection check
*1 Shows "----" when a device is offline.
NOTE
• Inverters connected via CC-Link IE network are not recognized properly.
• The LED all-OFF setting and the connection check ON/OFF setting are available for direct connection of the FR-A800/FR-
F800 with the FR-A8NCG in it or the FR-E800-E.
• Those settings are enabled when online communication is established between the inverter and FR Configurator2.
• LEDs may not blink depending on the Pr.1399 setting even when the connection check is enabled. Refer to the Instruction
Manual of the inverter for the details.
 For use of the connection check ON/OFF setting
• Before using the connection check ON/OFF setting, check the setting of parameters in the following table.
Model Intermediate
device
FR-E800-(SC)E Not connected
Set all the devices selected in the project to online.
• FR-A800/FR-F800 inverter with FR-A8NCG in it
Used to turn OFF the ACT LEDs on all successfully connected inverters.
• FR-E800-(SC)E
Used to stop the blinking of the NET LEDs on all successfully connected inverters.
All the station numbers set in the project are displayed.
Shows the connection status.
Switch from offline to online and from online to offline.
Shows the operating status.
Shows operation commands. Shows "----" if there is no start command.
Shows the operating mode.
Shows the current warning. Shows "----" if there is no warning.
Shows if a connection error has occurred when the connection status is switched from offline
to online.
• FR-A800/FR-F800 inverter with FR-A8NCG in it
Used to turn ON the ACT LEDs on successfully connected inverters or plug-in options (FR-
A8NCG) to blink in the communication check of FR Configurator2. (The blinking LEDs will
automatically turn OFF five minutes after the start of blinking.)
ON
• FR-E800-(SC)E
Used to turn ON the NET LEDs on successfully connected inverters to blink in the
communication check of FR Configurator2. (The blinking LEDs will automatically turn OFF
five minutes after the start of blinking.)
• FR-A800/FR-F800 inverter with FR-A8NCG in it
Used to turn OFF the ACT LEDs on successfully connected inverters or plug-in options (FR-
A8NCG) in the communication check of FR Configurator2.
OFF
• FR-E800-(SC)E
Used to stop the blinking of the NET LEDs on successfully connected inverters in the
communication check of FR Configurator2.
Pr.
1427 Ethernet function selection 1
1428 Ethernet function selection 2
1429 Ethernet function selection 3
1430 Ethernet function selection 4
Function and Description
*1
*1
Name
Set "45237" in any of the parameters.
*1
*1
Setting
157
3. FUNCTION
3.7 Diagnostics
1
2
3
4
5
6
7
8
9
10