Diagnosis Result Output; Ethernet Status - Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual

NOTE
• For EtherCAT communication, the main circuit capacitor's life cannot be measured during control using the controlword. To
measure the main circuit capacitor's life, disable the control using the controlword.
 Procedure of main circuit capacitor life measuring
1.
The "Check before measurement" instructions are shown. Check the following items, and click [Next].
Motor is connected.
Motor is stopped.
2.
The "Preparation for measurement" instructions are shown. Set the operation mode in which parameters can be
written and click [Next].
Set Pr.259 Main circuit capacitor life measuring to "1".
3.
The "Power-OFF" instructions are shown. Turn OFF the inverter power, and click [Next].
4.
The "Power-ON" instructions are shown. After confirming that the power lamp is OFF, switch ON the inverter power
again, and click [Finish].
3.7.4

Diagnosis result output

Select [Diagnosis result output...] in the [Diagnose] menu to output the diagnosis data of the selected station and save the data
in a CSV text file.
[Diagnosis result output...] is also available in the pop-up menu. (Refer to
3.7.5

Ethernet status

The Ethernet status check function is available for the following models.
Model: FR-A800-E, FR-F800-E, and FR-E700-NE
Click [Next].
Click [Next].
Click [Next].
Click [Finish].
page 83.)
1
2
3
4
5
6
7
8
9
10
155
3. FUNCTION
3.7 Diagnostics