Table of Contents
Advertisement
|
|
|
|
|
|
Controls and indicators for the SAN Volume Controller
Power button
|
4
Installation Guide
Application programming interfaces:
The SAN Volume Controller provides the following application programming
interface:
v IBM TotalStorage Common Information Model (CIM) Agent for the SAN Volume
Controller, which supports the Storage Management Initiative Specification of
the Storage Network Industry Association.
All the controls for the SAN Volume Controller are located on the front panel (see
Figure 14).
1
3
2
2145
Figure 14. SAN Volume Controller front panel assembly
1 Power button
2 Power LED
3 Check LED
4 Navigation buttons
5 Select button
6 Front panel display
7 Node identification label
Related topics:
v "Node identification label" on page 6
v "Power button"
v "Power LED" on page 5
v "Check LED" on page 5
v "Navigation buttons" on page 5
v "Select button" on page 5
v "Front panel display" on page 5
The power button 1 switches the main power to the SAN Volume Controller on
or off.
To turn on the power, press and release the power button.
To turn off the power, press and release the power button.
Attention: If a SAN Volume Controller is powered off for more than five minutes
and it is the only SAN Volume Controller connected to an uninterruptible power
supply, the uninterruptible power supply will also power off. To power on the
SAN Volume Controller you must first power on its uninterruptible power supply.
4
5
6
7
Advertisement
Table of Contents
