Chapter 4. Tcpiip Lan-Attached Remote Workstation Configuration; Configuring A Target Service Processor; Types Of Tcp/Ip Service Lan-Attached Remote Workstations - IBM 3745 Console Setup Manual

o
o
o
o
o
Chapter 4. TCP/IP LAN-Attached Remote Workstation
Configuration
i
i
TCP/IP
d?
~
o
LAN-Attached
Workstation
I
TCP/IP
d?
~
LAN-Attached
Workstation
I
CJ
3745
CJ
3746
900NN
TIC3 at 2080
Figure 4-1. Types of TCPI/P Service LAN-Attached Remote Workstations
i
LAN-Attached
Workstation
d?
!MOSS-E!
~
Service
Processor
I
This chapter shows you how to configure a DCAF session for controlling a target
service processor.
The path between the controlling workstation and the service processor can be
either through:
• A
bridge
with filtering to the service LAN (see
D
in Figure 4-1).
• A router to the service LAN, which can be either:
- A non-3746 router (see
fJ
in Figure 4-1)
- The 3746 router (see
II
in Figure 4-1).
A controlling workstation can be connected as in
fJ
or
II,
but you cannot
have both types of connections at the same time.
Configuring a Target Service Processor
Important---------------------------------------------,
You can use the worksheets in the Planning Guide, GA33-0457 to record the
necessary parameter values described in this section.
The following procedure configures the MOSS-E to answer a controlling
workstation:
Step 1. Open the Service Processor Menu.
Step
2. Click
Configuration Management.
© Copyright IBM Corp. 1989, 1998
4-1