Extron electronics NAV E 101 DTP User Manual page 45

RESET tab
Reset or reboot the encoder as follows:
1. On the page, click Reset (see figure 33,
Device Tools
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
Figure 33. Device Tools — Reset Function
2. Select (click) a reset level (see figure 33,
NOTES:
• Reset Device Settings (Retains TCP/IP Settings and Password) —
Resets configuration settings. All communication settings and the password
are retained (see the
page 35).
• Reset All Settings and Delete Files (Retains TCP/IP Settings) —
Resets configuration settings except the communication settings, which are
maintained. Resets the password to the default, which is extron (see the
table of communication and configuration settings).
• Reset All Settings and Delete Files — This reset is identical to the Mode 5
reset (see the table
settings to factory defaults).
3. Click APPLY ( ).
4
The encoder reports that it is
displays a status bar that shows the progress of the
operation. Any of these operations concludes with the
encoder rebooting.
NOTE: You must reconnect to the encoder (see
Opening the Embedded HTML Pages
if you have additional operations to perform.
1
) or Reboot (
2
table of communication and configuration settings on
of rear panel reset modes on page 13, which resets all
and
Resetting Rebooting
on page 15)
NAV E 101 DTP Encoder • HTML Operation
).
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
).
3
and
37