Extron electronics NAV E 101 DTP User Manual page 33

Loop Thru pane
See figure 16. If you change any of the settings in the
( through ), the button (
SAVE
1 5
CANCEL ( ) to abandon them. Clicking either button closes the dialog box.
7
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5
6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6
Figure 16. Loop Thru Pane
HDCP Mode — Click the drop-down list to select between
1
the following two output modes for the HDMI Output port (see
on page 6).
B
• — Mimics the HDCP encryption state of the
Follow Input
connected source.
• — Maintains the HDCP encrypted state with
Alway Encrypt
the output sink device to improve system switching performance.
Video Output — Click the drop-down list to select among
2
the various output formats and colorspace for the HDMI Output
port ( ). The table below shows the available formats.
B
Format
Auto (based on the EDID of the sink
[default])
DVI RGB 444
HDMI RGB 444 Full
HDMI RGB 444 Limited
Color Bit Depth — Click the drop-down list to select
3
between the following two output formats for the HDMI Output
port ( ).
B
• Auto — Adjusts color bit depth based on the display EDID
(10 bit or 8 bit) (default).
Force 8-Bit — Always uses 8 bit output.
•
Allow Audio Only — Click to toggle Audio Only on and off. Audio only prevents a
4
display with no video source from going to standby by generating a blackburst signal.
NOTE: Allow Audio Only must be disabled to use the NAV screen saver (see
Screen Display (OSD) pane
Loop Thru Configuration
) becomes selectable. Click SAVE to take changes or
6
7 7 7 7 7 7 7 7 7 7 7 7 7 7 7 7 7 7
Format
HDMI YUV 444 Full
HDMI YUV 444 Limited
HDMI YUV 422 Full
HDMI YUV 422 Limited
on page 28).
NAV E 101 DTP Encoder • HTML Operation
dialog box
On
25