Assign Master Faders; Go / Back Buttons; Lcd Windows; Clear Output From A Stack - Jands Event Plus Operating Manual

Control Functions - Playback
13F Go/Back Buttons
7 8 9
MEMORY EDIT
5 6
4
PAGE ASSIGN
2
1
CLEAR
BUILD
0
EXIT SETUP RECORD
13G Clear button
90 Event V3 Manual

13.52 Assign Master Faders

The Assign Master faders controlling a Stack do two things:
1. During a crossfade they act as fade override controls. The left hand fader
2. When the crossfade is completed the left hand fader becomes a level control
Normally the faders are left up (at 100%). When they are in this position they do not
affect the timing of the crossfade (to take manual control of the crossfade see
Section 13.70).

13.53 Go / Back Buttons

The Flash button below the left hand fader is the GO button for a Stack. Pressing
the GO button initiates the infade of the next Cue and the outfade of the current
(stage) Cue.
The Flash button below the right hand fader is the BACK button for a Stack.
Pressing the BACK button returns the current (stage) output to the previous Cue.
It is only possible to back up one cue.
13.54 LCD Window
When a Stack is on, the LCD window shows the current (on stage) Cue label above
the right hand fader and the next Cue label above the left hand fader. When the
stack is first turned on there is no output to stage so the right hand display is blank.
NOTE:

13.60 Clear Output From a Stack

CHASE
To clear the output from a Stack:
FILE
3
1. Press the Clear button on the function keypad.
STACK
2. Press the Go button of the Stack to be cleared.
Clearing a Stack snaps the current output from the Stack to zero level. However,
the Stack is still ON and a new infade can be started by pressing GO.

13.70 Taking Manual Control of a Fade

It is not unusual to need to take control of a Cue to allow for changes that occur in
a live performance. A performer might be late arriving on stage or skip over some
part of the show.
1. The left hand fader controls the infade. To take manual control of an Infade
Diagram 13E 2
controls the Infade rate of the cue fading in and the right hand fader controls
the Outfade rate of the cue fading out.
scaling the level of the current Memory or Chase.
Diagram 13F
Diagram 13C
When a Cue is running the display changes to show the percentage of fade
completed and the time, in seconds, left to run.
Diagram 13G
move the fader to match the elapsed fade percentage. The LCD window
changes to show MAN: / 20% (or whatever fade percentage has elapsed).