Advanced Channel Control; Setting Channels To Ignore Crossfade Timing; To Set Channels To Ignore Timing - Jands Event Plus Operating Manual

Advanced Features
114 Event V3 Manual

18.00 Advanced Channel Control

18.10 Setting Channels to Ignore Crossfade Timing

When a timed crossfade is being used it can be useful to set some channels to ignore
the timing information. For example, you might want to snap change a colour
scroller while slowly fading the intensity.

18.11 To Set Channels to Ignore Timing:

Diagram 18A
Press the Setup button to open the Setup Menu.
1
Move the cursor to the UTIL (Utilities) field.
2
3
Press the (On) button to open the Set Utilities menu.
4 Move the cursor to the PREC (Precedence) field.
Press the (On) button to open the Setup Precedence menu.
5
6
Move the cursor to the CHAN# field and set a start channel number.
7
Move the cursor to the THRU (Through) field and set an end channel
number.
TIP:
If you just want to set one channel, leave this field the same as the CHAN# field.
8 Move the cursor to the PREC field and set it to LAST.
Repeat steps
9 2
Press Exit to close this menu (press Exit several times to close all menus).
10
to for any other channels or groups of channels.
8