To See The Changes In A Build Memory - Jands Event Plus Operating Manual

15.20 To see the changes in a Built Memory
There are two Methods to see changes in a Built Memory:
METHOD 1
1. Edit the Memory that is being Built from (i.e. in our example the focus
Memory)
2. Assign the Built memory to one of the Assign faders.
NOTE
: If the Built Memory is already on an Assign fader just Assign the same Memory
over the top of it.
METHOD 2
1. Load the Page containing the Built memory
NOTE
: If the Build Memory is part of the Page on the Assign faders just reload the same
Page.
2. Fade in the Built memory to see the changes.
TIP:
After recording a number of position memories, set them up as a Stack so that
when recording Built Memories you can 'scroll' through various position settings.
Colour and Beam information can also be recorded and used in the same way.
© Jands Electronics May 1995
Event V3 Manual 103