Club Car XRT 950 2009 Maintenance And Service Manual page 165

TROUBLESHOOTING AND ELECTRICAL SYSTEM
7.2. Place the black (–) probe of multimeter into the black wire terminal (w44) of the wire harness and use an
alligator clip to attach the red (+) probe onto the positive (+) battery terminal. If the multimeter reading is
approximately 12 volts, the black wire has continuity.
8. Check the continuity of the headlight jumper harness wires.
9. If the readings are correct in all of the previous steps, replace the headlight bulb.
WAVETEK 5XL
V
V OFF
1000 500
200 200
20
200
2 2m
200
20
m
m
200
2000
m
k
200k
20k 200
2k A
!
V ! COM 200nA
MAX
1000 ---
FUSED
750V
485
Figure 11-51 Check Voltage to Headlight Socket
TEST PROCEDURE 23 – Front Differential Disable Switch (Optional)
See General Warning on page 1-2.
NOTE: The front differential disable switch is only used with the auto-locking front differential starting mid-2012
model year.
1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
2. Remove the front differential disable switch from the instrument panel. See Front Differential Disable Switch
Removal on page 12-8.
3. Note which terminal each wire connects to and then disconnect all wires from switch.
4. Connect multimeter probes to terminals and operate switch to verify continuity when in the 4x4 position and no
continuity when in the 4x2 position (Figure 11-52, Page 11-37). If continuity does not change while operating the
switch, replace switch.
WAVETEK 5XL
V
V OFF
1000 500
200 200
20
200
2m
2
200 20
m
m
200
2000
m
k
200k
200
20k
A
2k
! !
V COM 200nA
MAX
1000 ---
FUSED
750V
2512
Figure 11-52 Front Differential Disable Switch Test
2009-2012 XRT 950 Maintenance and Service Manual
11
Test Procedures
Page 11-37