Rear Halfshaft Removal; Rear Halfshaft Installation; Shifter Cable Adjustment - Club Car XRT 950 2009 Maintenance And Service Manual

TRANSAXLE AND HALFSHAFTS

REAR HALFSHAFT REMOVAL

See General Warning on page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Pry out the thin axle nut flange where it is staked to the groove in the halfshaft (Figure 17-22, Page 17-7)
and loosen the axle nut (Figure 17-23, Page 17-7).
951
Figure 17-22 Undo Staked Flange Of Axle Nut
3. Lift and support the rear of vehicle and remove the wheel. See Lifting The Vehicle, Section 3, Page 3-4.
4. Raise the cargo bed and secure with the bed locking pin. See Cargo Bed, Section 4, Page 4-20.
5. Remove the rear shock absorber. See Rear Shock Removal, Section 9, Page 9-1.
6. Use a pry bar to disconnect the halfshaft from the transaxle (Figure 17-20, Page 17-5) and (Figure 17-21,
Page 17-5).
7. Remove the axle nut and push the halfshaft out of the hub.

REAR HALFSHAFT INSTALLATION

1. Installation is the reverse of removal.
2. Tighten the shock absorber hardware to 70 ft-lb (95 N·m).
3. Tighten the axle nut to 142 ft-lb (193 N·m) and then stake the nut to the groove in the halfshaft.
4. Install wheel and lower vehicle. See Wheel Installation, Section 8, Page 8-2.
5. Place bed locking pin in the stowed position and lower the cargo bed. See Cargo Bed, Section 4, Page 4-20.
6. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles on page 1-4.

SHIFTER CABLE ADJUSTMENT

See General Warning on page 1-2.
1066
Figure 17-23 Loosen Axle Nut
2009-2012 XRT 950 Maintenance and Service Manual
Rear Halfshaft Removal
Page 17-7
17