STEERING AND FRONT SUSPENSION
1189
Figure 7-21 Front Wheel Bearing and Hub
FRONT WHEEL BEARINGS AND HUB INSTALLATION
1.
Thoroughly clean and lubricate bore of steering knuckle.
2.
Press new bearing into bore until fully seated (Figure 7-21, Page 7-13). See following CAUTION.
CAUTION
• To prevent bearing damage, only push against the outer race to install bearing.
3.
Lubricate inner race of bearing and press hub in until fully seated. See following CAUTION.
CAUTION
• To prevent bearing damage, support the inner race while installing hub.
• Do not press against the lug bolts. Press only against the center of the hub.
2009-2012 XRT 950 Maintenance and Service Manual
Front Wheel Bearings and Hubs
7
Page 7-13