Club Car XRT 950 2009 Maintenance And Service Manual page 81

BRAKES
9. Remove the seat and the six screws that secure the seat panel to the chassis (Figure 6-27, Page 6-20). Remove
seat panel and set aside.
10. Disconnect the green wires (w30 and w53) from the limit switch (if equipped) mounted on the side of the park
brake handle assembly (Figure 6-28, Page 6-21).
11. Remove the two nuts, washers, spacer and bolts that secure the handle assembly to the chassis and let the
handle assembly rest on the floorboard (Figure 6-29, Page 6-21). Be sure to retain the spacer that fits between
the sides of the handle assembly (Figure 6-30, Page 6-21) and (Figure 6-31, Page 6-21).
12. Remove the cotter pin (Figure 6-32, Page 6-22), washers and clevis pin that attaches the compensator link
to the park brake handle (Figure 6-33, Page 6-22).
1031
Figure 6-28 Disconnect Two Wires From Park Brake
1049
Figure 6-30 Spacer Located In Handle Assembly
Switch
2009-2012 XRT 950 Maintenance and Service Manual
1042
Figure 6-29 Park Brake Handle Resting on Floorboard
1048
Figure 6-31 Remove and Retain Spacer
Park Brake System
Page 6-21
6