Fueling Instructions - Club Car XRT 950 2009 Maintenance And Service Manual

10

Fueling Instructions

4. Remove knob (1) and plate (2). Carefully remove the foam pre-cleaner (3) and air filter cartridge (4) assembly to
prevent debris from entering carburetor. See following NOTE.
NOTE: To clean foam pre-cleaner, separate it from cartridge and wash in liquid detergent and water. Squeeze dry
in a clean cloth. The air filter cartridge and foam pre-cleaner are specifically designed for this engine. Use
only engine-compatible air filter cartridges and foam pre-cleaners designed for your engine. Do not oil
the foam pre-cleaner.
817
Figure 10-14 Air Filter Element
Air Filter Installation
1. Reassemble clean (or new) pre-cleaner on clean (or new) cartridge.
2. Place the air cleaner assembly into the air filter housing.
3. Place the housing cover on the top of the air filter housing.
4. Secure the housing cover with both retaining clips.
5. Replace the center plastic access panel (1) (Figure 10-3) and lower and latch the cargo bed.
FUELING INSTRUCTIONS
See General Warning on page 1-2.
DANGER
• Turn the key switch to the OFF position before fueling.
• Do not pour fuel into the fuel tank when the engine is hot or while it is running.
• To avoid electric arc caused by static electricity, the fuel storage/pumping device must be grounded. If
the pump is not grounded, the vehicle must be grounded to the pump before and during the fueling
operation.
• To avoid the possibility of fire, clean up any spilled fuel before operating the vehicle.
1. Remove the fuel cap and fill the tank with fuel. See preceding DANGER and following NOTE.
Page 10-14 2009-2012 XRT 950 Maintenance and Service Manual
1
PERIODIC MAINTENANCE