Neutral Switch Installation; Carburetor Solenoid; Carburetor Solenoid Removal - Club Car XRT 950 2009 Maintenance And Service Manual

12

Carburetor Solenoid

1151
Figure 12-1 Neutral Switch Removal

NEUTRAL SWITCH INSTALLATION

1. Install the neutral switch in the transaxle housing. Tighten to 20.5 in-lb (27.8 N·m).
2. Connect the two-pin connector between the neutral switch and the wire harness.
3. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles on page 1-4.
CARBURETOR SOLENOID
See General Warning on page 1-2.
The carburetor solenoid is located on the bottom of the carburetor.
TESTING THE CARBURETOR SOLENOID
See Test Procedure 16 – Carburetor Solenoid Circuit on page 11-31.

CARBURETOR SOLENOID REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Remove the two screws and small front cover panel, located in front of the carburetor, from the engine.
3. Disconnect the white bullet connector in the carburetor solenoid red wire (Figure 12-2, Page 12-3).
4. Remove the solenoid from the carburetor (Figure 12-3, Page 12-3). See the Briggs & Stratton Vanguard
engine manual (CC P/N 103568101).
Page 12-2 2009-2012 XRT 950 Maintenance and Service Manual
ELECTRICAL COMPONENTS