Verifying The Generated Signal With The Graphics Display - R&S SMM100A Getting Started

®
R&S SMM100A
Generated is a periodic marker with marker frequency of 120 KHz. The signal
is output at the User 1 connector of the R&S SMM100A (see
3. Use a suitable cable to connect the User 1 connector of the R&S SMM100A to
the monitoring instrument, for example oscilloscope like R&S
ure 5-7.
Figure 5-7: Simplified representation of a test setup for signal monitoring**
** = The figure depicts the cabling as a general principle
4. Use a suitable cable to connect the
the monitoring instrument.
To learn more about this topic, refer to chapter "Regular Marker Output Sig-
nals" in the user manual.
5.5 Verifying the Generated Signal with the Graph-
ics Display
It is often useful to check the spectra of the configured signals, before you enable
the RF output of the instrument.
The R&S SMM100A provides a build-in function to represent the generated signal
on a graphical signal display. We demonstrate this feature by showing the charac-
teristics at one particular point of the signal processing chain. You can, however,
display the signal characteristics at other different stages.
Getting Started 1179.1335.02 ─ 02

Verifying the Generated Signal with the Graphics Display

I OUT
Trying Out the Instrument
connector of the R&S SMM100A to
Figure 5-5).
®
RTO. See Fig-
54