Mounting The R&S Smm100A In A Rack - R&S SMM100A Getting Started

®
R&S SMM100A
2. CAUTION! Foldable feet can collapse. See
on page 8.
Always fold the feet completely in or out. With folded-out feet, do not place
anything on top or underneath the product.
3. WARNING! A stack of products can fall over and cause injury. Never stack
more than three products on top of each other. Instead, mount them in a rack.
Stack as follows:
● It is best if all products have the same dimensions (width and length).
● The overall load on the lowest product must not exceed 500 N.
● With smaller products on top of the lowest product, the overall load on the
lowest product must not exceed 250 N.
max. 500 N
Correct
4. NOTICE! Overheating can damage the product.
Prevent overheating as follows:
● Keep a minimum distance of 10 cm between the fan openings of the prod-
uct and any object in the vicinity.
● Do not place the product next to heat-generating equipment such as radia-
tors or other products.
3.4.2 Mounting the R&S SMM100A in a Rack
To prepare the rack
1. Observe the requirements and instructions in
on page 8.
2. NOTICE! Insufficient airflow can cause overheating and damage the product.
Design and implement an efficient ventilation concept for the rack.
Getting Started 1179.1335.02 ─ 02
max. 250 N
Different dimensions
Setting Up the R&S SMM100A
"Setting up the product"
Too many instruments
"Setting up the product"
Preparing for Use
15