Connecting To Hs Dig I/Q - R&S SMM100A Getting Started

®
R&S SMM100A
► Follow the instructions in
3.12

Connecting to HS Dig I/Q

The HS Dig I/Q connector comprises a QSFP+ (Quad Small Form-factor Plugga-
ble) socket, that has two components: a QSFP+ cage and a QSFP+ connector.
The QSFP+ cable is equipped with the QSFP+ plug.
1 = QSFP+ plug
2 = QSFP+ cage
3 = QSFP+ connector
The connector is located on the
To connect to HS Dig I/Q interface
1. For connection, use the QSFP+ cable R&S DIGIQ-HS.
See "Cable selection and electromagnetic interference (EMI)"
2. Hold the QSFP+ plug of the cable by its panes.
3. Turn the QSFP+ cable, so that the release tab shows upwards.
4. Insert and push the QSFP+ plug into the QSFP+ cage.
To disconnect from HS Dig I/Q interface
1. NOTICE! If you pull the cable, you can damage the cable and the HS Dig I/Q
connector.
Pull the release tab.
Getting Started 1179.1335.02 ─ 02
"To connect to screwable connectors "
rear panel .
Preparing for Use
Connecting to HS Dig I/Q
on page 21.
on page 16.
23