R&S SMM100A Getting Started page 34

®
R&S SMM100A
User x
BNC multipurpose connectors for defining input signals and output signals.
The Table 4-6 lists the signals assigned to the User x connectors in the default
instrument state.
Table 4-6: Default configuration of the User x connectors
User connector
1
2
A dedicated LED indicates the connector status:
●
green: an input connector
●
yellow: an output connector
●
no light / gray: the connector is not active
See also chapter "Global Connector Settings" in the user manual.
RF
Output of the RF signal.
The connector type depends on the maximum frequency f
Table 4-7: RF connector types of the frequency options
Installed RF frequency
option
R&S SMM-B1003/-
B1006/-B1007
R&S SMM-B1012/-
B1020/-B1031
R&S SMM-B1044/-
B1044N
Note: The PC 1.85 mm male connector for up to 44 GHz comes with a protective
1.85 mm female adapter to prevent the sensitive connector from damage.
It is available as a spare part, and can be replaced if damaged. Contact your
Rohde & Schwarz support center or
information.
How to: Chapter 3.9, "Connecting to
Getting Started 1179.1335.02 ─ 02
Direction
Output
Output
Connector type
N female
PC 2.92 mm female
Instrument equipped with interchangeable
PC 2.92 mm test port adapter.
PC 1.85 mm female
Instrument equipped with PC 1.85 mm inter-
changeable female/female wear and tear
adapter.
www.customersupport.rohdeschwarz.com
RF",
Default assigned signal
max
on page 20
Instrument Tour
Front Panel Tour
, see table below.
Frequnecy range
≤ 7.5 GHz
f
max
≤ 40 GHz
f
max
≤ 44 GHz
f
max
for
34