Table of Contents
Advertisement
®
R&S
SMM100A
EFC
BNC connector for input of an EFC (external frequency control) signal for elec-
tronic tuning of the internal reference frequency.
IEC 625/IEEE 488
General purpose interface bus (GPIB) interface for remote control of the instru-
ment. The interface is in compliance with the standards IEC 625, IEEE 488 and
SCPI.
Use this interface to connect a computer for remote control of the
R&S SMM100A. To set up the connection, use high-quality shielded cables. See
"Cable selection and electromagnetic interference (EMI)"
See also "Annex: Hardware Interfaces" and chapter "Network and Remote Con-
trol" in the user manual.
Dig I/Q
Connectors for the input of a digital I/Q signal from a Rohde & Schwarz instru-
ment, like a signal generator.
HS Dig I/Q
Option: R&S SMM-B9
Connectors for the input/output of high-speed digital I/Q signals, for example,
from and to Rohde & Schwarz instruments.
For more information, see data sheet.
The interface is a QSFP+ (Quad Small Form-factor Pluggable) module. It sup-
ports max. bandwidth of up to 50 Gsample/s with optical active cables.
How to:
Chapter 3.12, "Connecting to HS Dig
Adv Data/Ctrl
Interface for exchanging of external data and control signals.
T/M/C
BNC multipurpose input/output trigger/marker/clock connectors.
There is one T/M/C and one T/M connector
The input/output signal has to be defined. The
the local connectors in the default instrument state.
Getting Started 1179.1335.02 ─ 02
on page 16.
I/Q",
on page 23
Table 4-9
lists the configuration of
Instrument Tour
Rear Panel Tour
38
Advertisement
Table of Contents
