Table of Contents
Advertisement
®
R&S
SMM100A
Figure 7-3: Taskbar fully assigned
1 = System configuration
2 = Remote control connections
3 = Graphics
4 = Dialogs
5 = Diagram / more
1
SystemConfig
2
Remote
3
Graphics
4
Dialogs
5
Diagram / more
7.3.4
Additional Display Characteristics
The following section provides a short insight on the indication of the screen in
general, and significant elements that you see under specific operating modes, in
dialogs or settings.
● Appearance of active elements
– Active elements like On/Off switches, state buttons have a blue back-
ground.
– Selected elements are framed or highlighted orange.
– Inactive elements are gray.
● On-Screen keypads
As additional means of interacting with the instrument without having to con-
nect an external keyboard, either a numerical or alphanumerical on-screen
Getting Started 1179.1335.02 ─ 02
Understanding the Display Information
Provides access to general system configurations
like setup, display, or remote.
Shows the established remote connections when
the instrument is remotely controlled.
Tip: An indicator in the status bar shows the current
remote control status.
Shows that a signal is represented graphically.
Shows a dialog as a thumbnail, the dialog name,
and the name of signal channel.
The diagram icon as shown in
all dialogs indicated on the screen. The block dia-
gram is in the foreground.
The "More" softkey indicates that more dialogs are
open than can be displayed in the taskbar. Use this
softkey to open a selection list with the remaining
active dialogs, and the "Diagram" function.
Instrument Control
Figure 7-2
minimizes
76
Advertisement
Table of Contents
